GE MDS-2310 Radio Configuration and Diagnostic Cable

Description

This Cable connects your laptop to the MDS-2310 Radio’s 25db female communication port.  The Cable includes two adapters, and one 14ft Ethernet cable.  The adapters are one female DB9 to RJ45(which connects to your laptop), and one male DB25 to RJ45(which connects to your Radio).   If your laptop doesn’t have a DB9 serial port, you will need to purchase a USB to Serial Adapter Cable which will provide you with a DB9 serial port. Then you can connect this adapter directly to it. Simply connect the DB9 adapter to your laptop, and the DB25 to the Radio.  Connect the 14ft Ethernet cable to each adapter. The RJ45 Ethernet Cable is a straight through cable, and can be replaced by any straight through cable for additional length (not to exceed 50ft).; The cable must be a straight through meaning pin 1 to pin 1 through pin 8 to pin 8. The setup of this cable reduces the quantity of cable gear you carry. I personally carry one straight through Ethernet cable and the two Adapters in a separate pouch in my laptop case. When I am plugging into the Ethernet network switches, I use this Ethernet cable. When I need to connect to a MDS-2310 Radio, I just pull out my two adapters, connect them to this Ethernet cable, and plug right in to the Radio! You will enjoy this quick setup and easy storage. You will need to obtain the MDS Configuration Software.  I personally use Version 2.4.0 of the MDS Configuration Software with this Configuration Cable to configure and use the diagnostic features on MDS-2310 Radios.  You can get the software from GE. This Cable is not made by GE. I personally make each cable and provide my personal email to each buyer if technical assistance is needed.  Each cable is quality tested before being shipped.